Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic safety inspection. Front brake pads at 10mm. Rear brake pads at 8mm. -Inflated tires to spec (35PSI) -Torqued lug nuts to spec (80ft. lbs.)
Service air conditioner. Check condition of all belts and lines. Evacuate and recharge with R-134. Test system performance. **Only recovered .78lbs- system slightly low on arrival- compressor beginning to seep- customer advised & will monitor. -After Service High side (175psi) Low side (35psi) Amb. temp. (93F) Vent temp (50F)
Frank M. gave our service a 5 star review on 9/17/2025
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic safety inspection. Front brakes at 10mm, rears at 8mm Tire pressure sety to 35 psi, Lug nuts torqued to 80 ft lbs. Tech noted radiator low- Leaking at hose connecting to water outlet below fresh air inlet hose
Edwin P. gave our service a 5 star review on 3/14/2025
Front brake pads at 3mm & rotors are grooved/ show signs of overheating. Rear brake pads less than 2mm & rotors grooved/worn. Recommend replace front & rear brake pads & rotors, & flush brake fluid. -Tech noted vehicle does pull to right & steering wheel is off aligned- recommend wheel alignment.
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Wheel alignment
Edwin P. gave our service a 5 star review on 12/20/2024
Brakes at 8mm front, 3mm reatr shoes- Driver side wheel bearing has play, 2 of 3 mounts are broken, engine crankcase 1qt over full. HAS SPACER INSTALL IN O2 SENSOR PORT ON CATALYST – WILL NOT PASS SMOG
David Q. gave our service a 5 star review on 11/8/2024
Scan vehicle to retrieve data & codes- P16BB- ACG (B) Terminal Circuit Low Voltage & P065A ACG No Charge Malfunction. Perform diagnosis & inspection- test charging & starting systems- found battery dated 7/24- dead on arrival- charge battery-holds a charge. Test alternator output low/weak. Recommend replace alternator & battery current sensor. After repairs retest- battery & alternator voltage at spec.
ALTERNATOR ASSEMBLY – Remove & Replace –
BATTERY SENSOR – Remove & Replace –
Frank M. gave our service a 5 star review on 9/12/2024
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic safety inspection. Front brake pads at 6mm. Rear brake pads at 4mm. Rear brakes low. -Recommend spark plugs at next service. -Torqued lug nuts to spec (80ft. lbs.) -Inflated tires to spec (32PSI)
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Replace Air Filter & Cabin Air Filter
Oscar Z. gave our service a 5 star review on 10/9/2023