Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic safety inspection. -Front brake pads at 8mm.
REMOVE & REPLACE FRONT PASSENGER TURN SIGNAL BULB & REAR DRIVERS BRAKE LIGHT BULB
Douglas C. gave our service a 5 star review on 3/31/2025
Lubricate and check chassis. Change oil and oil filter. Check all fluid levels and tire pressures. Perform basic safety inspection. Front brakes at 10mm, rears at 8mm Tire pressure sety to 35 psi, Lug nuts torqued to 80 ft lbs. Tech noted radiator low- Leaking at hose connecting to water outlet below fresh air inlet hose
Edwin P. gave our service a 5 star review on 3/14/2025
-Front brake pads at 9mm. Rear brake pads at 7mm. -Lug nuts torqued to spec (100ft. lbs.) -Tires inflated to spec (F40PSI, R47PSI) -Did not rotate tires due to different sizes.
Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Check thermostat and electric cooling fan operation. Inspect hoses and clamps.
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Remove coils to gain access to spark plugs- tech noted coil boots burned- recommend replace all.
Isaiah F. gave our service a 5 star review on 2/24/2025
Interface with computer to retrieve trouble codes & data- *P1450- Unable to bleed up fuel tank vacuum- test system- purge solenoid stuck closed. -Perform diagnosis- system operating to spec at this time- If fault returns recommend replacing purge solenoid
Tianna W. gave our service a 5 star review on 2/5/2025